Those plugs have very accurate mechanical tolerances (unlike many cheap connectors). If you are using 1/4-inch jacks, then cables made with Neutik/Rean plugs tend to be the most reliable. Short splitters using a single 1/4-inch male plug to dual 1/4-inch female sockets (then used with male/male cables) tend to be very unreliable because in-line 1/4-inch female sockets don't have enough room for proper spring-loaded contact designs. If those outputs have 1/4-inch TS connectors, you should be using a cable with all male connectors. loop pedal and mixer have mono outputs." so it sounds like you're possible feeding the mono output to a stereo amplifier input. 3.5 mm female jacks tend to be some of the least reliable connectors used in audio and can be easily damaged. 1/4-inch TS to dual TS splitters are reliable if they are used with good, not overly worn out jacks. RCA to dual RCA splitters are usually fairly reliable, but sometimes need to have the male RCA plug tightened to properly fit some jacks. "Y" splitter adapters and splitter cables are available with almost any combination of connectors. they only work if I jiggle them into the "sweet spot" and if I so much as look at them the wrong way after that they stop working.As already asked, please provide the details of the connectors you're using. If then the Clean/Dirty Channel switcher doesn't change channels, just plug the mono cable into the other jack on the TRS - Dual TS Pedal.Īnd if you still want to use your reverb or tremelo on your amp, just get another small, single button 1/4" TS foo TSwitch and plug it into the other jack on the TRS - Dual TS Pedal.I bought two Monoprice mono to stereo adapters on Amazon and they are junk.
Then, connect a mono cable up to one of the mono outpu TS on the TRS - Dual TS Pedal and then to the "Clean/Dirty Channel" switcher's "Channel" jack. Just plug a TRS cable into the amp's TRS channel jack and then to the "In" of the TRS - Dual TS Pedal. (works in reverse as well mono y splitter > stereo)Īlso works great in addition to our "Clean/Dirty/Channel" switchers and "Single Loop Channel Effect" switchers where your amp may utilize a TRS cable to switch channels but the original amp foo TSwitch has reverb or tremelo on it too.
Plug your 1/4" stereo cable ( TRS) into the "In" jack and then connect your 1/4" mono cables ( TS) to the other jacks to split both sides of the TRS cable to wherever you want to send it.
0 kommentar(er)
